TPC Coalescing Air Filter 0.01um 3/4" NPT Compressor Oil Separator PFU5-N06-L

TPC Pneumatic UPFU5000-06* Inlet & Outlet: 3/4" NPT
Drain Type: Manual Drain
Max. Pressure: 250 PSI
Element: 0.01 Micron
Compressed Air After Filter: Particle & Moisture, Oil Vapor, Micron Mist Remover Installation Install units so the airflow is in the direction “IN-OUT” as indicated by arrow on the head of the unit. Filter should be installed upstream of regulators. If an air dryer is being used, install the filter downstream from the dryer. PPFU must be installed in vertical, downstream position for proper function.  In most cases, an PPF particulate pre-filter with a 10 micron absolute element is recommended to greatly extend the life of the element. When the element becomes clogged with dirt, it must be replaced. A pre-filter will remove water and dirt before it reaches the Coalescing Filter and will reduce maintenance costs.Operation & Adjustments: Oil Mist Filters are used for high filtration of oil aerosols and sub-micron particles. They are often used with critical instrumentation; paint spraying equipment; more sophisticated air systems; blow molding bottling; in the food industry, and where air blows on a finished product. The Coalescing Filter, eliminate micro-particle like rust, carbon of .01 micron or greater. This Stage Air Drying Unit offers general industrial filtration with low pressure drop and long element life. They are often used with older compressor where downstream oil carryover is excessive and longer element like and low pressure drop are a concern If the filter is installed properly, it should give long trouble-free service. The pressure drop across the filter should not exceed 10 PSI. If the pressure drop exceeds 10 PSI, either the filter element needs to be replaced or the unit is being operated beyond its capacity and a larger size unit is required. Operating the filter at a pressure drop in excess of 10PSI will greatly reduce the efficiency of the filter. If oil appears downstream: 1) check downstream air lines to be sure that they are free of residual oil; 2) check to see that the filter element of O-ring are in good condition and installed properly.